Hi i have a new Scotle SL-460 50W (From ChinaCNCZone.com), and i want to upgrade my machine to use Cohesion3D and Lightburn Software, can i easy swap cable on this board? (Mine dont use flat cable at all…)

Thanks for all

images/e25e022055051679ed0f985385293bbd.jpeg

“Felipe Jos\u00e9 de Oliveira”

Ray Kholodovsky (Cohesion3D) June 30, 2018 16:14

I think so. Check the instructions at cohesion3d.com - Getting Started - there is the wiring without the flat cable and then you will have to cut the big power plug and put 24v, Gnd, and L to screw terminals on the C3D board.

Felipe José de Oliveira June 30, 2018 16:26

Cool xD, and the laser fire is the LO from mine right?

Ray Kholodovsky (Cohesion3D) June 30, 2018 16:28

Yes, that is it. I call it “L” a lot. ^^

What power supply is in your laser? These are usually shit and cause problems with the board. I am getting high quality 24v 4a power bricks to power the C3D board (and thus the motors) with, expect to have them available in 2 weeks.

Felipe José de Oliveira July 02, 2018 14:11

Cool, and i can add a relay module to control my air compressor on/off when the laser is on?

Imported from Google+ — content and formatting may not be reliable