Just received a Cohesion3D Mini for my K40 Laser Cutter My old board and hookups don't seem to match any examples I've been able to find
Just received a Cohesion3D Mini for my K40 Laser Cutter
My old board and hookups don’t seem to match any examples I’ve been able to find.
The ribbon cable makes sense.
The 4-Pin connector goes to the Y-Control position?
The other cable is 6-Pin and has 3 wires, Green, White and Pinkish? I’m assuming these are for power but no idea where they might go?
Any help would be appreciated
Thanks
Dennis
“Dennis Moran”
Ray Kholodovsky (Cohesion3D) December 12, 2017 03:08
That’s the much older moshiboard :)
See if this thread helps you:
plus.google.com - Let me start with a big thanks for creating this board! It has renewed my in…
Dennis Moran December 12, 2017 05:23
So it looks like:
Green = Ground
White = 24V
Pink goes to P2.5/BED connector on the Mosfet block?
Ray Kholodovsky (Cohesion3D) December 12, 2017 13:33
It seems that way, you may want to confirm the 24v and Gnd with a multimeter
Richard Vowles December 12, 2017 17:45
I’m pretty sure this is the same as mine. I’m going to actually try and do something with it this holiday!
John Sturgess December 12, 2017 21:03
You can also use this for reference with the older boards.
plus.google.com - Moshi Board V4.6 Upgrade. I thought I’d post some pictures up of my current c…
Dennis Moran December 14, 2017 02:00
I hooked the board as described above:
Green = Ground
White = 24V
Pink goes to P2.5/BED connector
Got the software to connect to the K40
Can move head up, down, left and right
Laser test fire works
Just have to learn the new workflow to see if everything else works, pretty new to this…
Thanks to everyone that helped!
Dennis
Imported from Google+ — content and formatting may not be reliable