Hey guys,

I am rebuilding the K40 and I was wondering if I could use the extra driver on the c3d used for the rotary to power a conveyor belt to move parts through the build plate area? I am thinking about cutting a door in the back and front so I can etch oars or driftwood and then have the rotary drivers move it back in forth into the xy area. Is this possible?

“Abe Fouhy”

Ray Kholodovsky (Cohesion3D) November 03, 2017 01:45

In theory, perhaps.

You would just use a gCode to tell it to move at the end of the job.

Abe Fouhy November 03, 2017 02:33

+Ray Kholodovsky That’s what I was thinking too, that is super cool! I will see how that mod progresses and I’ll give you and update!

Imported from Google+ — content and formatting may not be reliable