Ray et al: I am considering using the external stepper adapter to drive external stepper drivers from my RAMPS board that uses the usual Pololu socket
Ray et al:
I am considering using the external stepper adapter to drive external stepper drivers from my RAMPS board that uses the usual Pololu socket.
Is there a data sheet or wiring schematic available? I am wondering which pins it uses.
Is there a provision to take +5V from VDD? Which ground pin does it use?
Any other thoughts or tips on using these?
Thanks
Dennis
“Dennis P”
Ray Kholodovsky (Cohesion3D) January 29, 2018 02:37
Ramps (if arduino is under it) will put out 5v signals. So if your stepper driver supports it hook those up to + and - to gnd.
Dennis P January 29, 2018 03:15
you mean VDD and Ground on the adapter? That is why I was asking about the ground pin.
Ray Kholodovsky (Cohesion3D) January 29, 2018 03:16
There is a Ground on the adapter. There is no VDD on the adapter.
Imported from Google+ — content and formatting may not be reliable