K40 Just stopped. Message at the bottom DMSG:'SH'l'SX' to unlock Another message DMSG Reset to Continue Haven't been able to locate any info on DMSG in the literature
K40 Just stopped. Message at the bottom DMSG:’SH’l’SX’ to unlock
Another message DMSG Reset to Continue
Haven’t been able to locate any info on DMSG in the literature.
If I disconnect the K40’s power and unplug my C3D board I can get the K40 to give me jog control but when I execute RUN the K40 and the k40 locks up and I get one of the error messages. GRBL firmware.
“bbowley2”
Joe Alexander December 20, 2017 18:45
suggestion: dont copy and paste all over the place. most of us are in all the groups I believe so repetitive posting is rather annoying.
LightBurn Software December 24, 2017 05:57
It’s just “MSG: $H or $X to unlock”. Usually you get that if you hit a limit switch, so check to make sure those aren’t tripped.
Imported from Google+ — content and formatting may not be reliable