Just a quick update. Board now mounted inside
Just a quick update.
Board now mounted inside.
main power now split to drive the pump when switched on.
Screen added.
I have not connected a computer yet, all controls off the screen for now.
So. Power up and all looks ok, getting things on the screen.
Can jog about and change the step size.
I am sure that the Y axis is inverted and moving it Y- should bring it towards the front of the machine but it moves towards the back.
On setting it yo do a return to home it wants to move to the front left corner, not the back left.
is there a way to reverse the axis or have I put something in wrong??
“Colin Rowe”
Ray Kholodovsky (Cohesion3D) January 29, 2017 17:04
Remove power. Flip the Y motor cable 180 degrees.
Colin Rowe January 29, 2017 17:09
the 4 pin that goes into the board?
Ray Kholodovsky (Cohesion3D) January 29, 2017 18:24
No, the smaller cable that is going to where it says “Y”. This is above the green motor driver board.
Imported from Google+ — content and formatting may not be reliable