When I command the laser to move using Lightburn the X-axis moves twice as far as it should
When I command the laser to move using Lightburn the X-axis moves twice as far as it should. When I was using K40whisper I was able to change it’s settings for X scale factor to 0.5 and then it moved 10 when I sent the command to move 10. How can I do this with Lightburn. I’m think this might occur because I had to replace the X-axis motor when I first purchased the K40 and it may not move T the sale rate.
“Frank Broadway”
Ray Kholodovsky (Cohesion3D) August 12, 2018 20:29
It’s in the board’s config.txt file on the memory card not in Lightburn.
Brian might have resources for you.
Frank Broadway August 12, 2018 20:31
+Ray Kholodovsky Thank’s
Tech Bravo (Tech BravoTN) August 12, 2018 20:55
im working something up for you now +Frank Broadway
Frank Broadway August 12, 2018 21:08
+Tech Bravo Thanks
Tech Bravo (Tech BravoTN) August 12, 2018 21:14
here ya go:
lasergods.com - Steps Are Off After Replacing A Motor
Frank Broadway August 12, 2018 21:24
+Tech Bravo Your solution worked perfectly! Thank you very much!
Tech Bravo (Tech BravoTN) August 12, 2018 21:39
+Frank Broadway you are welcome.
Imported from Google+ — content and formatting may not be reliable