Hi all I'm looking for yet more help if anyone has the time or is able too
Hi all I’m looking for yet more help if anyone has the time or is able too.
I have a c3d mini with a fault on the Y output, fully tested and its just dead.
its no big hassle as there is the 2 unused outputs “Z&A”
Ray said to just swap the Dir,step and en from the beta to the A, this is simple enough but I don’t have the “A” output in the config text just the apha,beta and gamma.
I don’t want to use the z output as I intend to add one in the near future.
can any one tell me the lines of code I need to add to enable the A output (I don’t need pin values they are easy enough for me to sort )or if anyone has a config text already configured with A output that would be great.
thanks in advance
Jim
“jim walker”
Tech Bravo (Tech BravoTN) September 14, 2018 13:55
4 axis config file can be found here if it helps any: lasergods.com - C3D 4 Axis Firmware & Config
jim walker September 14, 2018 14:07
+Tech Bravo Many thanks I’m sure it will be a great help
Ray Kholodovsky (Cohesion3D) September 14, 2018 14:25
Consult the pinout diagram or the 4 axis config file. But keep the config file you had just manually change the pins.
jim walker September 14, 2018 14:57
+Ray Kholodovsky With you thanks ray
jim walker September 14, 2018 15:53
It worked a treat thanks both for your help
Imported from Google+ — content and formatting may not be reliable