I got a cohesion3d board last week
I got a cohesion3d board last week. I just installed it in my system. When I plug it into the usb cable it connects to the computer and all 5 lights light up and the 2-3 light blinks but when I turn on machine the first five light stay green and 2-3 blink but the vmot lights red. I have tried to reset and have removed all cables except the laser and 24v cables and no change. I have not down loaded or installed the software yet.
“james blake”
james blake April 29, 2018 21:24
I just tried without the usb cable connected and the same result.
Ray Kholodovsky (Cohesion3D) April 29, 2018 21:33
Sounds normal. What’s the problem you are trying to solve?
james blake April 29, 2018 21:52
I did not know if the red vmot light was normal or a problem, I have seen that you needed the first 4 light and 2-3 blinking but did not see anything about a red vmot. I thought it was an error light.
Ray Kholodovsky (Cohesion3D) April 29, 2018 21:58
A lot of people think that it seems. It just means the board is getting 24v power from the laser. Carry on!
james blake April 29, 2018 22:20
Ok thanks, it is just when see red light that had always meant error or trouble. Now just have to figure out the x-y motor connection and end stops and I might have it working. At lest now I know every thing is starting up normal.
Imported from Google+ — content and formatting may not be reliable