Would it be possible to wire this as a stop for the z table and try and addauto focus?
Would it be possible to wire this as a stop for the z table and try and addauto focus?
“William Kearns”
Don Kleinschnitz Jr. July 11, 2017 22:07
Looked at this once and decided that its likely not accurate enough. I would use a “BL touch sensor though (below).
You would need a companion processor to handle the control algorithm unless you added smoothieware code. You could interface that controller as a switch closure to the C3D i/o.
Imported from Google+ — content and formatting may not be reliable