Anyone having issues with the latest build of LaserWeb4?
Anyone having issues with the latest build of LaserWeb4?
I upgraded to 4.0.48 last night after using 4.0.45 all week just fine.
Now I’m dead in the water.
Running K40 with C3D board.
Latest Firmware-cnc.bin
Latest LaserWeb4 4.0.48
Machine recognizes firmware and connects.
Will not jog.
Manually can test fire.
C3D LED status:
L1 - Green
L2 - Blinking Green Rapidly
L3 - Blinking Green Rapidly
L4 - Green
3V3 - Green
VMot - Red
I’ve re-booted computer.
I’ve manually reset C3D.
I’m going to reformat/reload SD card and re-boot to see if that helps.
Open to suggestions????
Kris
“Kris Sturgess”
Frank Dart April 08, 2017 03:37
I just got my c3d today and installed latest laserweb as well… same issue. I threw the stock board back in just to make sure I didnt screw something up.
I’ll probably give it another go tomorrow.
Kris Sturgess April 08, 2017 12:41
+Frank Dart I got it going. One of the settings reverted back when I upgraded. Check to see if you are running mm/sec or mm/min. I prefer mm/sec for my speeds.
Imported from Google+ — content and formatting may not be reliable